Knowledge Base Knowledge Base Node Software BPL Node Setup

            BPL Core Node Setup

            Setting up a BPL Core node

            This article will guide you through the set-up of a BPL Corenode (either forging or relay) on the BPL Core network.


            Setting up a BPL Core node is relatively easy, but it will help to have some experience with SSH and using the Linux terminal as well as managing a Virtual Private Server (VPS).

            If you're new to this, don't worry. Help is available by joining the BPL discord channel at for advice.

            Hardware Specifications

            To ensure a stable and consistent internet connection, a VPS (Virtual Private Server) provider with a guaranteed up-time of 99% or greater. There are many affordable providers available by a www search for "VPS provider".

            The minimum recommended specifications for a BPL Core node are:

            Forging node:
            1. Processor: 2 cores
            2. RAM: 8 gigabytes
            3. Solid State Drive: 100 gigabytes
            Relay node:
            1. Processor: 1 core
            2. RAM: 4 gigabytes
            3. Solid state drive: 100 gigabytes

            Ports Needed

            The BPL Core node software needs the following ports to be opened for proper functioning:
            1. HTTP and SSL (for install and updates): Ports 80 & 443
            2. SSH (for node administration): Port 22
            3. BPL Core Specific: Ports 4200, 9030, & 9031

            Operating System

            The BPL Core node has been verified compatible with Ubuntu 16.04 and Ubuntu 18.04. Ubuntu is an open source operating system can often be pre-installed depending on your VPS provider. If not, installation media is available at or

            Setup Process

            Now for the fun stuff... You'll have your BPL Core node up and running in about 15 minutes by carefully following the steps below, on a suitable VPS running Ubuntu 16.04 or 18.04.
            1. Add the user "bpluser" and grant the new user sudo access
            2. Log in as bpluser
            3. Run the following command to start the install process:
            4. Press [Enter] on your keyboard if you see the following prompt (will not occur for all OS configurations):

            5. When you see the prompt "What network do you want to operate on?", use the arrows on your keyboard to select "mainnet" (or "testnet" if you are participating).
            6. Press "Y" on your keyboard when you see the prompt "Can you confirm?"
            7. Press "y" on your keyboard when you see the prompt "Would you like to configure the database? [y/N]"
            8. Enter a username for your database when you see the prompt "Enter the database username" then press [Enter] on your keyboard
              It is recommended that you use a different username than the user (bpluser) you created in step 1 of this guide
            9. Enter a password for your database user when you see the prompt "Enter the database password"
              It is recommended that you use a strong password that is different from the bpluser password you set in step 1 of this guide
            10. Enter a name for your database when you see the prompt "Enter the database name"
              We recommend that your database be named "bpl_mainnet" for a mainnet node or "bpl_testnet" for testnet
            Thats it... you have successfully installed and configured your BPL Core node!

            Next steps

            Now that your node is installed, you'll need to start it. This will is covered in the knowledge document Basic BPL Core Node Management.

            As always, feel free to visit us at for advice and assistance.

            Updated: 01 Aug 2019 04:15 AM
            Help us to make this article better
            0 0